DC Audio
DC Audio Pitbull 20K A3 20,000w Mono Block Amplifier
- SKU:
- DC Audio Pitbull 20K A3
- Availability:
- Ships within 2 business days
- Weight:
- 75.00 LBS
- Shipping:
- Calculated at Checkout
Description
The 20.0kw competition series amplifier is a 20,000 watt mono block. It is built for 12 volt audio systems. It will not operate on 16 or 18 volt systems. It is a linkable amp and designed to run at 1 ohm per amp or 2 ohms when strapped for 20,000 watts of power. It comes with a bass knob and a clipping indicator. For power inputs it will accept triple 0 awg for power and triple 0 awg for ground.
Key Features
• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
• Triple 0 awg power and ground inputs
We recommend for installation
• 1 upgraded battery under the hood
• 3 extra 800ci battery in the rear
• Minimum of two 0 awg ran from the front battery to the rear batterys
• All 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 6 runs into the amp
• 2 upgraded aftermarket alternators
• Dash mounted voltage meter
Features | Voltage | 20.0kw | |
Output Power (RMS) | 4 ohm | 14.4V | 3,000W x 1 |
2 ohm | 5,500W x 1 | ||
1 ohm | 10,000W x 1 | ||
1 ohm | 16V | N/A | |
1 ohm | 18V | N/A | |
Input Sensitivity | 6V~0.2V | ||
Low Pass Filter | Switchable | ||
( @ 24 dB Slope) | Variable | Hz | 35~250 |
Subsonic Filter | Switchable | ||
( @ 24dB slope ) | Variable | Hz | 10~50 |
Bass Boost | Variable | dB | 0-9dB |
Frequency Response | Hz | 15-270 | |
Signal to Noise Ratio | dB | 100 | |
Damping factor | 150< | ||
Efficiency @ 4ohm | % | Over 90% | |
THD @ 4ohms | Less than 0.1% | ||
Fuse Rating | 1,000 Amps | ||
Linked Fuse Rating | 2,000 Amps | ||
Indicator | Power | Yes | |
Protection | Yes | ||
Clip | Yes | ||
Speaker & Power terminal | Mold Type | Yes | |
Power | Gauge | 0Ga x 3 | |
Heatsink Length | 37.75 | ||
Heatsink Width | inch/mm | 11.5 | |
Heatsink Height | 2.6 |